Remote ADB

Remote ADB lets you run ADB (Android Debug Bridge) commands wirelessly from your phone to other Android devices — no root required. Whether you're using Android 12+ with built-in pairing UI or older Android versions, this app simplifies wireless debugging and remote control.

🔧 Features:

• 📡 Connect to devices over Wi-Fi (ADB wireless debug)

• 🔐 Pair devices via ADB Pairing Code (Android 12+)

• 🧑‍💻 Run shell commands directly from your phone

• 🧩 Support for both modern and legacy ADB connection methods

• 📲 No root required, minimal setup

📱 How to Use – Android 12 and Above:

1. On the target device, go to:

Settings > Developer Options > Wireless Debugging

2. Enable Wireless Debugging

3. Tap “Pair device with pairing code”

4. Open this app on the controller device – it will automatically scan and detect nearby devices

5. Tap the detected device → Enter the pairing code → Done!

6. Now you can send ADB commands from your phone

📶 How to Use – Devices Without Pairing Mode (Android 11 and below):

These versions do not support built-in ADB pairing UI, but you can still connect wirelessly:

1. Connect the target device to a PC via USB

2. On your PC, run the command:

adb tcpip 5555

3. Disconnect USB – now the device listens for ADB over Wi-Fi

4. Find the device IP from Settings > About > Status

5. Open this app → Enter IP:5555 and connect

6. You're now ready to send ADB commands remotely

Note: Ensure USB Debugging is enabled on the target device.

⚠️ Requirements:

• Developer Options and USB Debugging enabled on the target device

• Wi-Fi connection (both devices must be on the same network for pairing)

🛡️ Disclaimer:

This app requires technical knowledge of ADB and is intended for developers, testers, and power users. Use responsibly.