We use cookies and other technologies on this website to enhance your user experience.
By clicking any link on this page you are giving your consent to our Privacy Policy and Cookies Policy.
Engine And Emission Basic Control System biểu tượng

4.0 by adeevastudio


May 25, 2018

Giới thiệu về Engine And Emission Basic Control System

Tiếng Việt

Động cơ và khí thải Hệ thống điều khiển cơ bản miễn phí tải về

This application informs and explains in detail about the engine control system and also comes with how to fix or solve problems with your car engine.

Precautions for On Board Diagnostic (OBD)

System of Engine

The ECM has an on board diagnostic system. It will light up the malfunction indicator lamp (MIL) to warn the driver of a malfunction causing emission deterioration.

CAUTION:

- Be sure to turn the ignition switch OFF and disconnect the negative battery terminal before any repair or inspection work. The open/short circuit of related switches, sensors, solenoid valves, etc. will cause the MIL to light up.

- Be sure to connect and lock the connectors securely after work. A loose (unlocked) connector will cause the MIL to light up due to the open circuit. (Be sure the connector is free from water, grease, dirt, bent terminals, etc.)

- Certain systems and components, especially those related to OBD, may use a new style slidelocking type harness connector. For description and how to disconnect, refer to EL section, “Description”, “HARNESS CONNECTOR”.

- Be sure to route and secure the harnesses properly after work. The interference of the harness with a bracket, etc. may cause the MIL to light up due to the short circuit.

- Be sure to erase the unnecessary malfunction information (repairs completed) from the ECM before returning the vehicle to the customer

TROUBLE DIAGNOSIS - INDEX

Engine Fuel & Emission Control System

Wiring Diagrams and Trouble Diagnosis

PREPARATION

ENGINE AND EMISSION CONTROL OVERALL SYSTEM

ENGINE AND EMISSION BASIC CONTROL SYSTEM DESCRIPTION

Multiport Fuel Injection (MFI) System

Electronic Ignition (EI) System

Air Conditioning Cut Control

Fuel Cut Control (at no load & high engine speed)

Evaporative Emission System

Positive Crankcase Ventilation

BASIC SERVICE PROCEDURE

Fuel Pressure Release

Fuel Pressure Check

Fuel Pressure Regulator Check

How to Check Idle Speed and Ignition Timing

Idle Air Volume Learning

ON BOARD DIAGNOSTIC SYSTEM DESCRIPTION

TROUBLE DIAGNOSIS - INTRODUCTION

TROUBLE DIAGNOSIS - BASIC INSPECTION

TROUBLE DIAGNOSIS – GENERAL DESCRIPTION

TROUBLE DIAGNOSIS FOR INTERMITTENT INCIDENT

TROUBLE DIAGNOSIS FOR POWER SUPPLY

DTC P0100 MASS AIR FLOW SENSOR (MAFS)

DTC P0115 ENGINE COOLANT TEMPERATURE SENSOR (ECTS) (CIRCUIT)

DTC P0120 THROTTLE POSITION SENSOR

DTC P0130 (RIGHT, -B1), P0150 (LEFT, -B2) FRONT HO2S (CIRCUIT)

DTC P0325 KNOCK SENSOR (KS)

DTC P0340 CAMSHAFT POSITION SENSOR (CMPS) (PHASE)

DTC P0605 ECM

DTC P1217 ENGINE OVER TEMPERATURE (OVERHEAT)

DTC P1335 CRANKSHAFT POSITION SENSOR (CKPS) (REF)

DTC P1336 CRANKSHAFT POSITION SENSOR (CKPS) (POS) (COG)

ABSOLUTE PRESSURE SENSOR

INTAKE AIR TEMPERATURE SENSOR

FRONT HEATED OXYGEN SENSOR HEATER

REAR HEATED OXYGEN SENSOR

REAR HEATED OXYGEN SENSOR

FUEL TANK TEMPERATURE SENSOR

CRANKSHAFT POSITION SENSOR (CKPS) (POS)

EGR VOLUME CONTROL SYSTEM

EVAP CANISTER PURGE VOLUME CONTROL SOLENOID VALVE

VEHICLE SPEED SENSOR (VSS)

IDLE AIR CONTROL VALVE (IACV) – AUXILIARY AIR CONTROL (AAC) VALVE

CLOSED THROTTLE POSITION SWITCH

A/T COMMUNICATION LINE

SWIRL CONTROL VALVE CONTROL SOLENOID VALVE

IGNITION SIGNAL

A/T DIAGNOSIS COMMUNICATION LINE

PARK/NEUTRAL POSITION (PNP) SWITCH

VARIABLE INDUCTION AIR CONTROL SYSTEM (VIAS)

INJECTOR

START SIGNAL

FUEL PUMP

ELECTRONIC CONTROLLED ENGINE MOUNT

POWER STEERING OIL PRESSURE SWITCH

REFRIGERANT PRESSURE SENSOR

ELECTRICAL LOAD SIGNAL

MIL & DATA LINK CONNECTORS

SERVICE DATA AND SPECIFICATIONS (SDS)

Fuel Pressure Regulator

Idle Speed and Ignition Timing

Mass Air Flow Sensor

EGR Temperature Sensor

IACV-AAC Valve

Resistor

Throttle Position Sensor

Calculated Load Value

Intake Air Temperature Sensor

Rear Heated Oxygen Sensor Heater

Crankshaft Position Sensor (REF)

Fuel Tank Temperature Sensor

Camshaft Position Sensor (PHASE)

Give your assessment, is this application useful?

if useful provide the best judgment for this app

thank you

This application do not need internet connection (can be used offline) Free download

Có gì mới trong phiên bản mới nhất 4.0

Last updated on May 25, 2018

The Engine And Emission Basic Control System application has been equipped with the latest features
1. images can be enlarged
2. equipped with instructions so easy to use
3. hd image quality (best in class)
4. free and complete app
5. easy to learn, easier to understand
6. New look, interesting and very cool

Đang tải bản dịch ...

Thông tin thêm Ứng dụng

Phiên bản mới nhất

Yêu cầu cập nhật Engine And Emission Basic Control System 4.0

Được tải lên bởi

'เหี้ย' 'บอย' ละอ่อนเหนือ

Yêu cầu Android

Android 2.3.2+

Hiển thị nhiều hơn

Engine And Emission Basic Control System Ảnh chụp màn hình

Đang tải bình luận...
Ngôn ngữ
Ngôn ngữ
Đăng ký APKPure
Hãy là người đầu tiên có quyền truy cập vào bản phát hành, tin tức và hướng dẫn sớm của các trò chơi và ứng dụng Android tốt nhất.
Không, cám ơn
Đăng ký
Đăng ký thành công!
Bây giờ bạn đã đăng ký APKPure.
Đăng ký APKPure
Hãy là người đầu tiên có quyền truy cập vào bản phát hành, tin tức và hướng dẫn sớm của các trò chơi và ứng dụng Android tốt nhất.
Không, cám ơn
Đăng ký
Thành công!
Bây giờ bạn đã đăng ký nhận bản tin của chúng tôi.