Simple DIY Vinyl Watchband

An Application That Teaches You Simple DIY Vinyl Watchband Instructions

this DIY challenge. we’ll admit this one stumped me because I rarely wear a watch anymore. Check out the how to for unique way to recycle an old watch whose band my be worn out or broken.

Supplies:

An old watch

Clear vinyl

One screw in button stud

Exacto knife or scissors

Flat back gems. You can use actual rhinestones or sticky back gems that are available in the scrapbooking section in most craft stores.

Nail polish

Jewel glue

Step 1: Cut off the band of an old watch. Be careful to cut so that you keep the bar on either side of the watch face.

Step 2: Measure your wrist with a tape measure and decide how long you want the band to be. I cut mine so that it would loop once – about 14 inches. Then measure the width of the bars of the watch face (this will vary depending on the size of your watch). Then cut your piece of vinyl.

Step 3: Slide the vinyl through the bars of of the watch face. At one end, cut a small slit.

Step 4: Attach a screw stud through the small slit. (Note: if you get some of these studs you definitely need to make this vinyl pouch too!)

Step 5: Put the band around your wrist and cut off any excess length. Then make another small hole on the other side of the band for the stud to fit through.

Want to know more ?

Download this application now and get what you want here. worth to try and you will like it.

simply share through any social media platforms. thank you for downloading. please enjoy and give us any feedback.