Consumer interest will flower as decoration in the room is likely to increase. Consumers want their room looked beautiful and lovely to provide decoration wreaths on each room. The amount of interest coming from consumers flower lovers, is able to provide ideas for businesses to create business opportunities imitation flowers made of plastic.
These plastic flower creations arise when consumers began to complain of the cost they should spend to buy real flowers which only hold for a few days. The beauty of a given real flowers can not be durable, the maximum can only last until the first week alone. Since then, many now appears the florist create plastic flowers. Usually the common material is plastic, ribbons, plastic straws, until the paper.
sedotanKualitas flower plastic flower creations are now marketed, has a shape that is very similar to the original flower. Plastic flowers so attractive also by consumers. Besides the shape similar to the original, plastic flowers can last longer than real flowers. And more interestingly, plastic flowers can be cleaned up if the start is dirty. Only by soaking with detergent, then it will be back bright color like new again.
Plastic flower creations can also be strung together, just like the original flower arrangements. With plastic flower pot along with gorgeous, gives a selling price is more expensive than the plastic flowers that are not threaded. So with a plastic flower creations we can open two business opportunities at the same time, retail business selling plastic flowers and plastic flowers to sell a string of gorgeous. Plastic flower creations can be used as one of the promising home-based business. Now the chances of success with a home business is very wide open.
Here we provide an example of how making the most simple plastic flowers, just use a used plastic straws that are around you.
tool: Scissor cutter glue
Material : Straw a stick or wire can be replaced with a rather large (approximately 2 mm diameter) crepe paper or can be replaced with paper tape former plastic bottles as additional accessories
Ways of making : Cut the straws with a length of ± 10 cm After the end of the straw is split into four, we can mengesut straw that has been cut so that the shape is more blooms and rather limp. Then cut each end of the straw which has dibesut, forming a taper like the shape of the original flower petals Some straws are then combined into one so shaped flowers in bloom This interest then we tie the wires or sticks that have been wrapped in crepe paper As for the leaves can be made from pieces of paper tape or sections of the former plastic glasses Once the flower stalk has finished, create the stalk - stalk the next in the same way. And for the last Rangkailah the flower stalks into a flower pot filled spoon / foam.